|
Operational procedure
|
Paint stage
|
Products
|
Notes
|
| |
II a
|
II b
|
|
|
|
Clean
|
x
|
x
|
Silicone remover
|
Spray on using pump atomiser and dry with highly absorbent
cloth.
|
|
Sand
|
x
|
x
|
Sanding/matting pad fine, blend prep.
|
Produce covered, matt surface when sanding. Wet sand. Allow to
dry.
|
|
Clean
|
x
|
x
|
Water, compressed air, silicone remover
|
Spray on using pump atomiser and dry with highly absorbent
cloth.
|
|
Spray basefix
|
x
|
x
|
Basefix
|
Mix Basefix using 200% universal thinner long. Painting stage II
a: Spray one layer of basefix covering the entire area. Painting
stage II b: Spray basefix only to adjoining part outside of damaged
area.
|
|
Spray base paint
|
x
|
–
|
Top-2-coat metallic base coat
|
Pre-spray only layer fading out into the adjoining part surface
and the individual part. Setting time 3 minutes.
|
|
Clean
|
x
|
–
|
Tack cloth
|
Remove dust (paint mist).
|
|
Spray base paint
|
x
|
–
|
Top-2-coat metallic base coat
|
Pre-spray second layer fading out past the fade-out zone of the
first layer into the adjoining part surface and the individual
part. Setting time 3 minutes.
|
|
Clean
|
x
|
–
|
Tack cloth
|
Remove dust (paint mist).
|
|
Spray base paint
|
x
|
–
|
Top-2-coat metallic base coat
|
Pre-spray third layer fading out past the fade-out zone of the
second layer into the adjoining part surface and the individual
part. Setting time 3 minutes.
|
|
Clean
|
x
|
x
|
Tack cloth
|
Remove dust (paint mist).
|
|
Spray clear coat
|
x
|
x
|
2-C-MS clear coat - long 2-C-HS clear coat - new
|
Pre-spray one layer. Setting time 3 to 5 minutes. Final spraying
with one more layer. Setting time 8 minutes prior to oven
drying.
|
