Electronic Brake Control Module Programming and Setup
The following service procedures require either a programming or
a setup event performed for a complete repair.
Electronic Brake Control Module Replacement
If the electronic brake control module (EBCM) needs to be
replaced, the following procedures must be performed:
2. |
Perform the SPS function
Electronic Brake Control Module - Programming and follow the
on-screen instructions. |
3. |
Perform the SPS function
Electronic Brake Control Module - Configuration & Setup and
follow the on-screen instructions. On the screen Control Module -
Configuration and Setup Function(s), select both ECU
Configuration/Reconfiguration and ECU Setup. |
4. |
Clear DTCs after completing
the programming procedure |
Electronic Brake Control Module Reprogramming
If the EBCM needs to be reprogrammed, the following procedures
must be performed:
2. |
Perform the SPS function
Electronic Brake Control Module - Programming and follow the
on-screen instructions. |
3. |
3. Clear DTCs after completing
the programming procedure. |
Setup for Component Replacement
The replacement of some components will require a setup
procedure for complete repair.
If any of the following components are replaced, the
corresponding procedure must be performed.
Steering Angle Sensor
Calibrate the steering angle sensor. Refer to
Steering Angle Sensor Centering
Multi-Axis Acceleration Sensor
Calibrate the multi-axis acceleration sensor. Refer to
Vehicle Yaw Sensor Learn
Brake Pressure Modulator Valve Assembly
Calibrate the brake pressure sensor. Refer to
Brake Pressure Modulator Valve Pressure Sensor Calibration
|