Headlamp Control Module Programming and Setup
The following service procedures require either a programming or
a setup event performed for a complete repair.
The following criteria must be met before performing the
programming or learning procedure:
| • |
The vehicle must be placed on
a flat level surface. |
| • |
There must be no occupants in
the vehicle. |
| • |
Any additional cargo weight in
the rear compartment must be removed. |
| • |
All doors must be
closed. |
Headlamp Control Module Replacement
If the headlamp control module needs to be replaced, the
following procedures must be performed:
| 2. |
Perform the SPS function
Headlamp Control Module - Programming and follow the on-screen
instructions. |
| 3. |
Perform the SPS function
Headlamp Control Module - Configuration & Setup and follow the
on-screen instructions. On the screen Control Module -
Configuration and Setup Function(s), select both control module
Configuration/Reconfiguration and the appropriate control module
Setup. |
| 4. |
Clear DTCs after completing
the programming procedure. |
Headlamp Control Module Reprogramming
Do not reprogram the headlamp control module unless directed by
a service procedure or a service bulletin.
| 2. |
Perform the SPS function
Headlamp Control Module - Programming and follow the on-screen
instructions. |
| 3. |
Clear DTCs after completing
the programming procedure. |
Setup for Component Replacement
The replacement of one or more components will require a setup
procedure for complete repair.
If the headlamp leveling sensor is replaced, perform the scan
tool learn procedure Automatic Headlamp Leveling Sensor Learn
listed below:
| 1. |
Connect a scan tool to the
vehicle. |
| 2. |
Verify the scan tool
parameters listed below are in the correct range: |
| |
• |
Front Leveling Position Sensor
Signal 10-90% |
| |
• |
Rear Leveling Position Sensor
Signal 10-90% |
| 3. |
Perform the procedure
Automatic Headlamp Leveling Sensor Learn. |
| 4. |
Clear DTCs after completing
the programming procedure. |
|
