Headlamp High Beam Control Module Programming and Setup
The following service procedures require either a programming or
a setup event performed for a complete repair.
Headlamp High Beam Control Module Replacement
If the headlamp high beam control module needs to be replaced,
the following procedures must be performed:
| 2. |
Perform the SPS function
Headlamp High Beam Control Module - Configuration & Setup and
follow the on-screen instructions. On the screen Control Module -
Configuration and Setup Function(s), select both control module
Configuration/Reconfiguration and control module Setup.
|
| 3. |
Clear DTCs after completing
the programming procedure. |
Headlamp High Beam Control Module Reprogramming
This device requires no programming.
|
