Heated Seat Control Module Programming and Setup
The seat heating control module must be programmed with the
proper calibration software. The module stores and utilizes this
information however if it is not properly configured with the
correct calibration software, the seat heating control module will
not control all of the vehicle features properly.
Ensure that the following conditions exist in order to prepare
for seat heating control module programming:
1. |
The battery is fully
charged. |
2. |
The MDI data link connectors
are secure. |
3. |
The scan tool is loaded with
the most current software version. |
4. |
All disconnected modules and
devices are reconnected securely. |
5. |
This entire procedure has been
reviewed before proceeding. |
Do not reprogram the seat heating control module unless directed
by a service procedure or a service bulletin.
Seat Heating Control Module Programming
To program and setup an existing or new replacement seat heating
control module, perform the following procedure:
2. |
On the SPS Supported
Controllers screen, select HVSMF Front Seat Heating Control Module
- Programming and follow the on-screen instructions. |
If the HVSMF Front Seat Heating Control Module fails to accept
the program, verify all scan tool and seat heating control module
connections are secure.
Note: After programming is
completed, perform the following to avoid future misdiagnosis:
1. |
Turn the ignition
OFF for 10 seconds. |
2. |
Open and close the
door. |
3. |
Connect the scan
tool to the data link connector. |
4. |
Ignition ON,
engine OFF. |
5. |
Clear all DTCs
from all modules. |
|