Trailer Lamp Control Module Programming and Setup
The following service procedures require either a programming or
a setup event performed for a complete repair.
Trailer Interface Control Module Replacement
If the trailer interface control module is replaced, the control
module programming procedure must be perform
2. |
Perform the SPS function
Trailer Interface Control Module - Configuration & Setup and
follow the on-screen instructions. On the screen Control Module -
Configuration and Setup Function(s), select both control module
Configuration/Reconfiguration and control module Setup.
|
3. |
Clear DTCs after completing
the programming procedure. |
Trailer Interface Control Module Reprogramming
Do not reprogram the trailer interface control module unless
directed by a service procedure or a service bulletin.
2. |
Perform the SPS function
Trailer Interface Control Module - Programming and follow the
on-screen instructions. |
3. |
Clear DTCs after completing
the programming procedure. |
|