Transmission Control Module Programming and Setup
The following service procedures require either a programming or
a setup event performed for a complete repair.
Transmission Control Module Replacement
If the transmission control module (TCM) needs to be replaced,
the following procedures must be performed:
| 2. |
Perform the SPS function
Transmission Control Module - Programming and follow the on-screen
instructions. |
| 3. |
Perform the SPS function
Transmission Control Module - Configuration & Setup and follow
the on-screen instructions. On the screen Control Module -
Configuration and Setup Function(s), select both Control Module
Configuration/Reconfiguration and Control Module Setup.
|
| 4. |
Clear DTCs after completing
the programming procedure. |
Transmission Control Module Reprogramming
Do not reprogram the transmission control module (TCM) unless
directed by a service procedure or a service bulletin.
| 2. |
Perform the SPS function
Transmission Control Module - Programming and follow the on-screen
instructions. |
| 3. |
Clear DTCs after completing
the programming procedure. |
Setup for Component Replacement
The replacement of following components will require to reset
learned values and N position calibration, refer to
Transmission Adaptive Functions .
The replacement of following components will require N position
calibration, refer to
Transmission Adaptive Functions .
| • |
Transmission control
replacement |
|
