Camshaft Position Actuator Solenoid Valve Replacement
Removal Procedure
1. |
Disconnect the intake camshaft
position actuator solenoid valve wiring harness plug (3).
|
2. |
Disconnect the exhaust
camshaft position actuator solenoid valve wiring harness plug
(2). |
3. |
Unclip ECM wiring harness (1)
from camshaft cover. |
4. |
Remove the 4 camshaft position
actuator solenoid valve bolts (1). |
5. |
Carefully rotate the intake
camshaft position actuator solenoid valve (1) counter clockwise as
shown. |
6. |
Carefully rotate the exhaust
camshaft position actuator solenoid valve (2) clockwise as
shown. |
|
Caution: The camshaft position actuator solenoid valves must be
kept parallel to the engine front cover during removal and
installation. The camshaft position actuator solenoid valves can be
damaged if they become wedged or stuck during this process.
|
7. |
Carefully remove the 2
camshaft position actuator solenoid valves (2) and the seal rings
(1). |
Installation Procedure
|
Caution: The camshaft position actuator solenoid valves must be
kept parallel to the engine front cover during removal and
installation. The camshaft position actuator solenoid valves can be
damaged if they become wedged or stuck during this process.
|
|
Note: Lubricate the
seal rings with oil in order to make the installation easier.
|
1. |
Carefully install the 2
camshaft position actuator solenoid valves (2) and the 2 seal rings
(1) by gently pressing into position. |
2. |
Install the 4 camshaft
position actuator solenoid valve bolts (1) and tighten to 8
N·m (71 lb in) . |
3. |
The 2 camshaft position
actuator solenoid valves should be installed in the position as
shown (1) and (2). |
4. |
Clip ECM wiring harness (1) to
camshaft cover. |
5. |
Connect the exhaust camshaft
position actuator solenoid valve wiring harness plug (2).
|
6. |
Connect the intake camshaft
position actuator solenoid valve wiring harness plug (3).
|
|