Tyco/AMP Connectors (Door Module)
Special Tools
| • |
EL-38125-580
Terminal Release Tool Kit |
| • |
J-38125-12A
Terminal Release Tool |
For equivalent regional tools, refer to
Special Tools .
Terminal Removal Procedure
Side view of connector.
View of top of connector.
| 1. |
Locate the assist lever and
lock on the top of the connector. |
| 2. |
While depressing the lock,
pull the lever over and past the lock. |
| 3. |
Disconnect the connector from
the component. |
| 4. |
Locate the dress cover locking
tabs at the rear of the connector. Use a small flat-blade tool to
release the locking tabs. Repeat this procedure for the other
locking tab. |
| 5. |
Once the locking tabs are
unlocked, slide the inner connector out of the rear of the
connector housing. |
| 6. |
Use the J-38125-12A tool to
release the terminals by pressing on the tang. |
| 7. |
While holding the removal tool
in place, gently pull the wire out of the back of the connector.
Always remember never use force when pulling a terminal out of a
connector. |
| 9. |
Insert the repaired terminal
back into the cavity. Repeat the diagnostic procedure to verify the
repair and reconnect the connector bodies. |
|
