Tyco/AMP Connectors (Sensor)
Special Tools
• |
EL-38125-580
Terminal Release Tool Kit |
• |
J-38125-11A
Terminal Release Tool |
For equivalent regional tools, refer to
Special Tools .
Terminal Removal Procedure
1. |
Disconnect the connector from
the component. |
2. |
Insert the J-38125-11A tool
into the cavity on the lower right hand face of the connector until
the terminal release tang access panel slides over. |
3. |
Ensure that the terminal
release tang access panel is in the correct location to access the
terminals. |
4. |
Push the wire side of the
terminal that is being removed toward the connector and hold it in
position. |
5. |
Insert the J-38125-11A into
the terminal release tang access slot located behind the access
panel of the connector and press down on the terminal while
carefully pulling the terminal out of the connector. Always
remember never use force when pulling a terminal out of a
connector. If the terminal is difficult to remove, repeat the
entire procedure. |
7. |
Insert the repaired terminal
back into the cavity. Repeat the diagnostic procedure to verify the
repair and reconnect the connector bodies. |
|