vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
Symptoms - Roof > < Fastener Tightening Specifications

Astra J

  • Roof
  • Sunroof
  • Diagnostic Information and Procedures
  • Miscellaneous
  • DTC B369D

DTC B369D

Diagnostic Instructions

•  Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
•  Review Strategy Based Diagnosis for an overview of the diagnostic approach.
•  Diagnostic Procedure Instructions provide an overview of each diagnostic category.

DTC Descriptors

DTC B369D 00: Sunroof Sunshade Actuator Malfunction
DTC B369D 39: Sunroof Sunshade Actuator Internal Malfunction
DTC B369D 42: Sunroof Sunshade Actuator Calibration Not Programmed
DTC B369D 4B: Sunroof Sunshade Actuator Calibration Not Learned

Circuit/System Description

The sunshade is controlled by its own integrated motor/controller containing the necessary electronics, motor, hall effect position sensors, as well as the interface to the driver control switches. The motor/controller is capable of controlling motion based on control switch activation and LIN-Bus message commands from the body control module (BCM).

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

B369D 00

The sunshade module has detected and reported via the LIN-Bus that the sunshade actuator has an malfunction.

B369D 39

The sunshade module has detected and reported via the LIN-Bus that the sunshade actuator has an internal malfunction.

B369D 42

The sunshade module has detected and reported via the LIN-Bus that the sunshade actuator calibration is not programmed.

B369D 4B

The sunshade module has detected and reported via the LIN-Bus that the sunshade actuator calibration is not learned.

Action Taken When the DTC Sets

DTC B369D is stored in the BCM memory.

Conditions for Clearing the DTC

The BCM no longer detects a malfunction in the sunshade actuator circuit.

Reference Information


Schematic Reference

Sunroof Schematics


Connector End View Reference

Component Connector End Views


Description and Operation

Sunroof Description and Operation


Electrical Information Reference


Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

1. Verify that DTC B369D 42 or DTC B369D 4B are not set.
⇒ If the DTC is set, program or calibrate the K62 Sunroof Sunshade Motor Module. If the DTC resets, replace the K62 Sunroof Sunshade Motor Module.
2. Replace the K62 Sunroof Sunshade Motor Module.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

•  Control Module References for sunshade motor/actuator replacement, setup and programming

  • Roof
  • Sunroof
  • Diagnostic Information and Procedures
  • Miscellaneous
  • DTC B369D

Symptoms - Roof > < Fastener Tightening Specifications