DTC B1015
Diagnostic Instructions
DTC Descriptor
| DTC B1015 00: Vehicle Identification Number
Information Malfunction |
Circuit/System Description
When the ignition is turned ON, the parking assist control
module and the vehicle direction camera control module receive the
vehicle identification number (VIN) from the body control module.
The control modules will compare the VIN received to the VIN stored
in memory.
Conditions for Running the DTC
Ignition voltage is between 9-16 V.
Conditions for Setting the DTC
The stored VIN does not match the received VIN.
Action Taken When the DTC Sets
| • |
The parking assist system or
the lane departure warning system is disabled. |
| • |
The driver information center
displays SERVICE PARK ASSIST or SERVICE LANE DEPARTURE
SYSTEM. |
Conditions for Clearing the DTC
The stored VIN matches the VIN stored in the body control
module.
Reference Information
Schematic Reference
Object Detection Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Object Detection Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Testing
| 1. |
Ignition ON, program the
control module the DTC originally set in. |
| 2. |
With a scan tool, clear the
DTCs. |
| 4. |
Wait 60 s, then ignition ON
and verify the DTC is not reset. |
| ⇒ |
If the DTC is reset, replace the control module
the DTC set in. |
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic
procedure.
Control Module References for the parking assist control
module, vehicle direction camera control module replacement, setup
and programming
|
