Field Remedy: 2792
| Subject: |
Seatbelt front or rear seat - Out and/or
back rolling mechanism does not work correctly |
| Models: |
Engines: |
Option: |
| All |
All |
|
| Complaint: |
Seatbelt does not roll back, or seatbelt
rolls back too slowly, or seatbelt difficult to pull out. |
| Cause: |
Clothes fibres, dirt, dust or twisted belt
webbing can cause seizing or blocking of the seatbelt. The seatbelt
itself is ok. The seat belt guiding system needs to be
checked. |
| Production: |
|
Remedy:
In Case of customer complaint, check D-loop (deflect mechanism)
for contamination regarding dirt, dust or webbing fibres.
Clean D-loop and seatbelt. Check function again by maximum pull
out.
Sealbelt webbing must not be twisted! If still an issue, demount
trim cover and check again.
If the seatbelt rolls back, no part must be replaced.
Reassemble Trim Cover and check function again. Take care of correct
positioning of Trim Cover. No bending should occur, no sharp edges
may have contact to the belt webbing!
Caution:
seat belt webbing should only be cleansed with warm water or suitable
low concentration commercially available products. Strong solvent
based products should not be used.
| FunctionalGroup: |
C - Equipment/Windows |
| Complaint Group: |
02 - Chafing,08 - Hard to operate,13 -
No/Poor Function |
| Trouble Code: |
|
|
