Callout
|
Component Name
|
1
|
Low and Reverse and 1-2-3-4 Clutch Housing
Tip
The longer legs face the bottom of the case and the oil passages
face the valve body end of the case.
|
2
|
Output Sun Gear Assembly
|
3
|
1-2-3-4 Clutch Waved Plate
Tip
Align the single pair of tabs with the bottom valve body end of
the case.
|
4
|
1-2-3-4 Clutch Plate (Qty: 2)
|
5
|
1-2-3-4 Clutch Plate Assembly (Qty: 2)
|
6
|
1-2-3-4 Clutch Backing Plate
Tip
Align the single skinny tab with the case spline facing the top of
the case.
|
7
|
1-2-3-4 Clutch Backing Plate Retainer Ring
|
Warning:
The retainer is under tension. Use care when
removing or installing the retainer. Personal injury could
result. |
|
Caution: Use caution during removal or installation of the
retainer ring to avoid damage to the case machined surface in the
park pawl area. Burrs or raised edges on the case machined surface
can cause the park pawl to bind and prohibit it from engaging the
park gear. |
Tip
| • |
Install the retainer with the
taper facing away from the backing plate. |
| • |
Align the retainer opening
with the largest gap in the case splines toward the bottom of the
case. |
| • |
Install one end of the
retainer into the retainer ring groove. Use DT-28585
circlip remover and work the retainer into the case groove.
Use a screwdriver to hold the retainer away from the case while
pushing down on the retainer with DT-28585 circlip
remover . |
Special Tool
DT-28585 Circlip Remover or equivalent
For equivalent regional tools, refer to
Special Tools .
|
