Minor Section, Repair - Rear Floor - Combo, Model 71
Minor Section Repair - Rear Floor - Combo, Model 71
General: The Service department continues to supply large lengths of floor sheet metal. For smaller damage, shorter sections of the floor sheet metal can be repaired.
Remove, Disconnect
Separate attaching parts from rear floor at a distance from the seam (1) corresponding to the degree of damage.
Install, Connect
Cut new floor panel to size with 20 mm added / overlap. Fit floor. Prepare flange. Apply spot weld paint. Weld in floor panel, seal cavities, attaching parts.
Important!
For body structural reasons, partial replacement must always cover the entire width of the floor and must be in straight lines!