Install, Connect
Slide steering wheel (1) with contact unit (2) onto steering shaft. Guide bolt of switch housing (3) must engage in guide of contact unit. Install retaining plate (2) on steering shaft and tighten steering wheel with nut - tightening torque 25 Nm / 18 lbf. ft. Secure nut.
Note: Installation of locking plate and nut releases contact unit at steering wheel catch lever.
Disconnect horn actuating plug and fasten in steering wheel recess (illus. II)
Connect wiring harness plug for airbag unit and horn and fasten in steering column bracket (illus. III). Install lower horn connection half.
Install airbag unit - see operation "Airbag Unit, Remove and Install".