Rear Quarter Window, Remove and Install - Model 71
 Remove, Disconnect Detach trim strip all around from rear quarter window (1). Detach inner rubber weatherstrip all around from rear quarter window (2). Notice: Rear quarter window trim strip will be destroyed and must be replaced. Mask pane frame with commercially available masking tape to prevent damage to the paintwork. | 
|
Remove, Disconnect Cut out pane using Cutting Wire MKM-589-A: Insert cutting wire (length approx. 400 mm) in rear side area (1) from the inside outwards through the adhesive bead. If necessary: make a hole through the adhesive bead beforehand with a small screwdriver (2). Cut out rear quarter window pane in a circular motion and remove with Suction Holder MKM-641. Lay rear quarter window aside on holding device. | 
|
Remove, Disconnect Screen removal using Swinging Blade MKM-846-1E or MKM-846-1P. Insert Cutting Blade MKM-846-28 at the lower rear corner from the outside into the adhesive bead and cut out rear quarter window pane in a circular motion. Remove rear quarter window using Suction Lifter MKM-641 and lay aside on holding device. | 
|
 Install, Connect Smooth down adhesive bead on pane frame to a thickness of 1 mm using Scraper MKM-846-70. Attach inner rubber weatherstrip for rear quarter window to pane frame - gap must be in the centre at the bottom. If re-using rear quarter window: Smooth down adhesive bead on rear quarter window to a thickness of 1 mm using Scraper MKM-846-70. Attach new rear quarter window trim strip (1). If using new rear quarter window: Clean area to be cemented, attach new rear quarter window trim strip (1). Apply glass primer "black" (I) and allow to set for 15 minutes. | 
|
Install, Connect Apply glass adhesive, use pre-cut applicator nozzle. Install rear quarter window with Suction Lifter MKM-641, only tension rear quarter window slightly with Tensioning Belt MKM-591.
 Important! For lay-over times of recently adhered glass panes in conjunction with glass adhesive and airbag equipment - see "Lay-over Times for Vehicles". Note processing instructions from adhesive manufacturer and on the packaging.
|
