Front Seat Belt, Remove and Install or Replace - Models 71, 78, 79, F 35
 Remove, Disconnect Remove B pillar panelling - see corresponding operation. Lever off panel (1) from lower belt anchor and unscrew bolt (2). | 
|
Inertia reel retractor (1) - unscrew bolt and detach inertia reel retractor from body panel.
 Install, Connect Attach inertia reel retractor in opening of B pillar and bolt on.
 Tighten (Torque) Inertia reel retractor to body - 35 Nm / 26 lbf. ft. | 
|
Install, Connect Install B pillar panelling - see corresponding operation. Bolt on lower belt anchor (2) and press on cover cap (1). Bolt on upper belt anchor and press on panel. |
|
Notice: When screwing on upper or lower belt anchor, ensure correct installing position of spacer (1) - i.e. long collar points towards height adjuster or inside sill, respectively - and of spring washer (2)!
Tighten (Torque) Safety belt to body - 35 Nm / 26 lbf. ft.
 Important! Only for vehicles with seat belt load limiter: the inertia reel retractors must be replaced after every accident in which the seat belt tensioner was triggered. | 
|
|
