|
C-03, circuit system voltage |
|
Test |
Work order description |
Nominal value |
|
T01 |
Check: Battery voltage |
|
|
|
• All loads switched off • Ignition ON • Measure voltage between following terminals: |
greater than 13 V |
|
|
Battery G1 + Terminal 30 & Battery G1 - Terminal 31
|
|
|
|
Yes: T02 |
No: E01 |
|
T02 |
Check: Battery voltage during engine start |
|
|
|
• Start engine • Measure voltage between following terminals: |
greater than 8 V,
Starter runs
|
|
|
Battery G1 + Terminal 30 & Battery G1 - Terminal 31
|
|
|
|
Yes: T03 |
No: E02 |
|
T03 |
Check: Alternator voltage |
|
|
|
• Engine runs • Measure voltage between following terminals: |
13...15 V |
|
|
Battery G1 + Terminal 30 & Battery G1 - Terminal 31
|
|
|
|
Yes: T04 |
No: E03 |
|
T04 |
Check: Control unit supply voltage |
|
|
|
• Ignition OFF • Disconnect wiring harness plug from: |
11.5...13.5 V |
|
|
K50 ABS control unit |
|
|
|
• Ignition ON • Measure voltage between following terminals: |
|
|
|
K50 ABS control unit Wiring harness plug terminal 15 & Ground
|
|
|
|
Yes: T05 |
No: E04 |
|
T05 |
Check: Ground connection of the control unit |
|
|
|
• Ignition ON • Measure voltage between following terminals: |
11.5...13.5 V |
|
|
K50 ABS control unit Wiring harness plug terminal 15 & K50 ABS control unit Wiring harness plug terminal 19
|
|
|
|
Yes: T06 |
No: E05 |
|
T06 |
Check: Tester |
|
|
|
• Ignition OFF • Connect wiring harness plug from: |
OK |
|
|
K50 ABS control unit |
|
|
|
• Ignition ON • Select using TECH1: |
|
|
|
F0:DATA LIST NO. T01 BATTERY VOLTAGE
|
|
|
|
Yes: E07 |
No: E06 |
