Crankshaft, Check (Out-of-Round)
Remove, Disconnect Remove oil pan - see operation "Oil Pan, Remove and Install" in this group. Remove central crankshaft bearing cap with bearing shell.
Measure Place dial gauge on centre crank pin and set to "0". Measure out-of-round by turning crankshaft. Maximum permissible out-of-round 0.05 mm.
Install, Connect |
|
Install bearing shells and bearing caps.
Tighten (Torque) Crankshaft bearing cap to cylinder block - 88 Nm / 65 lbf. ft.
Install, Connect Install oil pan - see operation "Oil Pan, Remove and Install". |
|
|