Camshaft Pulse Pick-up, Remove and Install
Remove, Disconnect
Push wiring harness plug for camshaft pulse pick-up (1) out of bracket on fuel distributor pipe and disconnect.
Unclip wiring harness from upper toothed belt cover and remove upper toothed belt cover.
Unbolt camshaft pulse pick-up from rear toothed belt cover (arrows) and remove.
Install, Connect
Fit camshaft pulse pick-up to rear toothed belt cover - insert bolts with bolt locking compound (red) - tightening torque 8 Nm / 6 lbf. ft.
Attach upper toothed belt cover - 4 Nm / 3 lbf. ft.
Connect wiring harness plug for camshaft pulse pick-up and insert in bracket on fuel distributor pipe.
Clip wiring harness for camshaft pulse pick-up into retaining lug on upper toothed belt cover (see illus.).