Engine Vent Flange, Remove and Install (X 14 XE)
Remove, Disconnect
Remove starter - see operation "Starter, Remove and Install".
Remove engine vent hose (1) from engine vent flange (2).
Remove engine vent flange from cylinder block.
Clean
Clean sealing surfaces.
Install, Connect
Insert new gasket (4) - note installation position, bead (3) must point upwards to engine vent flange.
Attach engine vent flange to cylinder block - tightening torque 8 Nm / 6 lbf. ft.
Attach engine vent hose to engine vent flange.
Install starter - see operation "Starter, Remove and Install".
Remove, Disconnect 
Clean 
Install, Connect 