vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

F0: Data List - Test Step 02 COOLANT TEMP. > < Checking with TECH 1

 

 

 

 

 

 

No.

TECH 1

Checking Conditions

Nominal Values

Trouble

Terminal

 

Display

 

 

Codes

 

 

 

 

 

 

 

 

 

 

 

 

 

01

BATTERY VOLTAGE

Ignition ON

11.5 to 13.5 V

-

A 6,B 1,

 

 

Start engine

> 8 V

 

C 16

 

 

Engine at idle speed

13.0 to 15.9 V

 

A 12,D 1,

 

 

Switch off all consumers

 

 

D 6

 

 

 

 

 

 

 

 

Trouble-shooting:                                 Nominal Value:                  Cause of Fault:

(If nominal value is not attained)

 

· Ignition ON                                                         > 11.5 V                                          · Battery discharged

With multimeter, measure                                                                                          - Battery short circuit in cell

voltage (20 V/DC) at                                                                                                   - Corroded contacts

battery and at wiring                                                                                                   - Voltage supply to K 100 contact

harness plug K 100    A 6, B 1, C 16                                                                             A 6, B 1, C 16 not OK.

to                                   A 12, D 1, D 6                                                                         - Ground connection to control unit not

OK. K 100 A 12, D 1, D 6.

- Plug connector X 5 Ter. 7 or X 16 Ter. A or

X 11 Ter. 5 interrupted (only KADETT-E)

- Relay K 58 or ignition control unit K 20 defective.

- Plug connector X 11 Ter. 1 interrupted or corroded.

- Control unit defective.

 

· Start engine                                                         > 8 V                                               · Check starter circuit

 

· Engine at idle speed                                          > 13 V                                             · Alternator or regulator defective

 

F0: Data List - Test Step 02 COOLANT TEMP. > < Checking with TECH 1