· Engine running for at least 40 s
· Coolant temperature higher than 85 °C/185 °F
· Throttle valve aperture
greater than 6 %
· Following trouble codes not
stored: 21, 22
· The fault is recognized by the control unit if
the oxygen sensor voltage is in the range 350 to 550 mV for longer than 12 s
(lead interruption, oxygen sensor
defective).
If
trouble code 13 was recognized, the control unit takes
450 mV as replacement voltage
(oxygen
sensor control switched off).
Note:
If
the oxygen sensor is wrapped in aluminium foil, remove the foil. Then delete
trouble code. If trouble code is set again, start trouble-shooting.
|