Vauxhall Workshop Service and Repair Manuals

Trouble-shooting:                                 Nominal Value:                     Cause of Fault:

(If nominal value is not attained)

Ignition ON, TECH 1 in Actuator Test mode "F5", test step 03

· Measure voltage at control                               Alternating display                          · Connecting line has short circuit to ground

unit K 100 Ter. D 4 to                                         0.02 to 0.8 V                                      - Connecting line has loose contact in plug

ground                                                                  or                                                           K 100 Ter. D 4

(at control unit plug!)                                          Display oscillograph                       · Control unit defective

image (square signal

with 2 Hz visible)

· Measure voltage at ignition                              Alternating display                          · Connecting line has lead interruption

module K 20 Ter. 4 to ground                          0.02 to 0.8 V

(at ignition module plug K 20!)                          or

Measuring range: (20 V/AC)                            Display oscillograph

image (square signal

with 2 Hz visible)

· Check voltage at ignition module                    Primary voltage OK                        · Check ground connection at ignition module

with TECH 80 K 20 Ter. 1                                                                                                K 20 Ter. 2 to 31

- Check voltage at ignition module K 20 Ter. 3 to 15

· Ignition module defective