Vauxhall Workshop Service and Repair Manuals

Inductive Pulse Pick-up, Remove and Install  

Notice: 

For a clearer representation, the wiring harness plug is shown with the upper part of the intake manifold removed.  

  Remove, Disconnect   

Detach wiring harness plug for inductive pulse pick-up (1).   Then release retaining spring using screwdriver and pull plug housing out of bracket.

  Remove, Disconnect   

Unbolt inductive pulse pick-up from bracket on oil pump housing (arrow).     Install, Connect    Insert inductive pulse pick-up into bracket - tightening torque 8 Nm / 6 lbf. ft.   At the same time, ensure everything is completely clean, otherwise the reference gap for the inductive pulse pick-up / increment disc may become to large, thus leading to operational malfunctions.   After installing the inductive pulse pick-up, the reference gap must be checked - see corresponding operation.   Insert plug housing for inductive pulse pick-up into bracket on fuel distributor pipe and connect wiring harness plug (1).   Secure wiring harness on engine, at the same time ensure correct cable routing.