C-04, Immobiliser Signal Circuit
Test
Work Order Description
Nominal Value
T01
Check: Component
• Select and enable diagnostic tester programming: IMMOBILISER
• Refer to B-7 F7: PROGRAMMING Test02 IMMOBILISER
Note:
In order to program the engine control unit, the immobiliser control unit must be programmed first.
Programming okay?
Yes: E01
No: E02
Result
Cause Of Fault
E01
• If programming/nominal value is okay and system is still faulty the following component is defective: Immobiliser
E02
• Short to voltage/ground/interruption of circuit between: K57 Control Unit - Multec Terminal D10 & K117 Control Unit - Immobiliser Terminal 7