|
C-13, Camshaft Position Sensor Circuit |
|
Test |
Work Order Description |
Nominal Value |
|
T01 |
Check: Short to Ground/Interruption of Voltage Supply Circuit |
|
|
|
• Disconnect wiring harness connector from:
P47 Sensor-Camshaft
L2 Ignition Coil • Ignition ON • Measure voltage between the following terminals:
P47 Sensor-Camshaft
Wiring Harness Connector (wiring harness side) Terminal A
&
Ground
|
greater than 11 V |
|
|
Yes: T02 |
No: E05 |
|
T02 |
Check: Circuit Interruption of Ground Circuit |
|
|
|
• Measure voltage between the following terminals:
P47 Sensor-Camshaft
Wiring Harness Connector (wiring harness side) Terminal A
&
P47 Sensor-Camshaft
Wiring Harness Connector (wiring harness side) Terminal C
|
greater than 11 V |
|
|
Yes: T03 |
No: E04 |
|
T03 |
Check: Short to Voltage/Ground/Interruption of Signal Circuit |
|
|
|
• Ignition ON • Measure voltage between the following terminals:
P47 Sensor-Camshaft
Wiring Harness Connector (wiring harness side) Terminal B
&
Ground
|
4.5 ... 6.0 V |
|
|
Yes: E01 |
No: T04 |
|
T04 |
Check: Short to Voltage/Ground/Interruption of Signal Circuit |
|
|
|
• Ignition ON • Measure voltage between the following terminals:
P47 Sensor-Camshaft
Wiring Harness Connector (wiring harness side) Terminal B
&
Ground
|
greater than 6.0 V |
|
|
Yes: E02 |
No: E03 |
