Test step "DESIRED IDLE
" is only active in TECH 1 mode "F8". Test
step "DESIRED IDLE "
may be used to test engine behaviour at increased speeds. Using the arrow
keys, it is possible to alter the speed within a range of 650 rpm to
1800 rpm. All other TECH 1 displays can be monitored
simultaneously. TECH 1 is automatically in the snapshot mode, so
that in the event of any unusual occurrence the memory function can be
immediately activated via "F9" key. TECH 1 uses the idle speed
stepper motor to set the speed to the desired value; a change in the "IDLE AIR CONTROL " display
is therefore not a fault.
|
· Select
TECH 1 mode "F8" and confirm with YES key.
· Engine
at idle speed, operating temperature
|
Engine speed increases to 1000 rpm
|
· Carry
out TECH 1 selection once again
· Check
idle speed regulator (test step 08)
· Check
throttle valve potentiometer (test step 04)
|
|