Support Plate, DIS Ignition Module, Remove and Install (X 12 SZ, X 14 SZ, C 14 SE)
Support Plate, DIS Ignition Module, Remove and Install (X 12 SZ, X 14 SZ, C 14 SE)
Remove, Disconnect
Remove wiring harness plug and high voltage ignition cable from DIS ignition module. Unbolt DIS ignition module from support plate. Unbolt support plate from camshaft housing (arrows).
Install, Connect
Install support plate with new seal ring in camshaft housing. Bolt DIS ignition module to support plate. Connect high voltage ignition cable and wiring harness plug to DIS ignition module.
Tighten (Torque)
DIS ignition module support plate to camshaft housing
- 12 Nm / 9 lbf. ft.
DIS ignition module to DIS ignition module support plate