Remove fastening nut from tie-rod end on steering knuckle. Press out tie-rod end with KM-507-C (1). Detach both retaining bands from bellows. Unscrew tie rod with axial joint (arrow) from steering rack (illus. II + III). Remove tie-rod end from tie rod and detach bellows.
 Install, Connect Bolt tie rod (arrow) with axial joint to steering rack - tightening torque 70 Nm / 52 lbf. ft. Fit bellows and secure to steering gear and tie rod with new retaining straps and KM-J-22610. Attach tie-rod end to tie rod - tightening torque 50 Nm / 37 lbf. ft. Attach tie-rod end to steering knuckle - tightening torque 35 Nm / 26 lbf. ft.
 Adjust Adjust toe-in - see operation "Chassis Alignment" in group "E". | 
Remove, Disconnect 