Vauxhall Workshop Service and Repair Manuals

Parts and Reference Lists  

General  

Cable connectors and shrink-down plastic tubing  

Designation / cross-section	Part no.	Catalogue no.
Cable connectors
0.5 / 0.75 / 1.0 mm 2	90 543 865	12 86 663
1.5 / 2.5 mm 2	90 543 866	12 86 664
4.0 / 6.0 mm 2	90 543 867	12 86 665
Shrink-down plastic tubing
0.5 / 0.75 / 1.0 mm 2	90 543 875	12 86 666
1.5 / 2.5 mm 2	90 543 876	12 86 667
4.0 / 6.0 mm 2	90 543 877	12 86 668

Retaining straps, adhesive tape and grooved pipes  

Designation	Part no.	Catalogue no.
Retaining strap
97 mm long	90 247 260	12 88 880
120 mm long	90 381 846	12 88 885
122 mm long	90 196 418	12 88 879
146 mm long	90 493 329	12 88 586
191 mm long	90 307 872	12 88 882
255 mm long	90 039 907	12 88 900
Adhesive tape
19 mm x 0.05 mm, 33 m roll	90 241 170	22 37 980
Grooved tube , in 5 m rolls
10 mm outer diameter	90 443 557	12 88 103
18 mm outer diameter	90 443 558	12 88 104
29 mm outer diameter	90 443 559	12 88 102

Wiring harness plugs with lead ends  

The following tables show indicate which replaceable wiring harness plugs are allocated to which crimping and detachment tools and the part and catalogue numbers.  

Application of tables  

•  Column 1 specifies the code of the available wiring harness plugs with lead ends. This code can be found in the current circuit diagram.
	-	As the components in the circuit diagrams that are designated "X" include both plugs and couplings, distinguishing suffixes have been added: "a" for couplings and "b" for plugs.
	-	If the table does not specify the code for the components, replace the entire wiring harness.
•  Column 2 specifies the handle colour of the crimping tool to be used.
•  Columns 3 and 4 refer to the detachment tools for the primary and secondary locks.
	Empty spaces for the detachment tools mean that the plugs or couplings can either be released by hand or with a commercially available screwdriver.
•  Columns 5 and 6 specify the part and catalogue numbers for the wiring harness plugs with lead ends.