|
Replace pulse emitter on wheel hub (vehicle with
disc brakes)
 Remove
| 2. |
Detach appropriate rear wheel
| • |
Unscrew 4 x screws
Note: Mark position in
relation to centre of wheel.
|
|
| 3. |
Detach brake calliper retaining frame with calliper
| • |
Remove brake calliper complete with linings and retaining
frame, and suspend at suitable point
Note: If the brake
calliper cannot be detached, remove the brake linings.
|
| • |
see operation "Brake Linings - Rear Wheel Brake, Remove and
Install" in group "H"
|
|
| 5. |
Detach dust cap (3)
Note: Dust cap cannot
be removed without damage
|
|
|
| 6. |
Remove wheel hub fixing bolt
|
| 7. |
Remove wheel hub (2) from wheel journal
|
| 8. |
Remove pulse emitter (3) from wheel hub
| • |
Using KM-161-B (4), remove hook KM-161-3 (5) and pressure pad KM-161-4 (6) from wheel hub.
|
|
|
|
| 9. |
Clean contact surfaces.
|
Install
| 10. |
Fit new pulse emitter to wheel hub.
| • |
Using KM-6175 (1) below a hydraulic
press, press down to contact on the wheel hub.
|
|
|
|
| 11. |
Clean wheel journal and thread on journal
|
| 12. |
Lightly coat wheel journal and bearing inner ring with oil
|
| 13. |
Fit wheel hub (1) to wheel journal
| • |
Push wheel hub onto journal
|
| • |
Fit new nut (2) on wheel spindle ( 175
Nm )
|
| • |
Fit new dust cap on wheel hub
|
|
|
|
| 14. |
Attach brake disc
| • |
Tighten bolt (1) ( 7 Nm )
|
|
| 15. |
Attach brake calliper
| • |
Place brake calliper with linings and retaining frame radially
over the brake disc
|
| • |
Coat 2x bolts (2) with locking compound and tighten ( 100 Nm )
Note: If the brake
linings were removed: install brake linings
|
| • |
see operation "Brake Linings - Rear Wheel Brake, Remove and
Install" in group "H"
|
|
|
|
| 16. |
Attach rear wheel
| • |
Tighten 4x bolts ( 110 Nm )
Note: Observe
installation position.
|
|
|
