|
Brake Hose, Front Left or Right, Remove and
Install
 Remove
| 1. |
Remove front wheel
| • |
Mark position in relation to centre of wheel
|
| • |
Pull seal away from plenum chamber as far as necessary
|
| • |
Raise covering flap for brake master cylinder
|
|
| 2. |
Detach closure cap (1) from brake fluid reservoir
|
| 3. |
Remove brake line (2) from front brake hose and close off
Note: The retaining
clip remains on the brake line.
|
| 4. |
Remove banjo bolt (3) of brake hose at brake calliper and
remove brake hose
|
|
|
Install
| 5. |
Insert brake hose in bracket
Note: Note guide lug on
front brake hose and bracket
|
| 6. |
Connect brake line (1) to front brake hose (3) using retaining
clip (2) - tightening torque 16 Nm
|
| 7. |
Connect brake hose without twisting using banjo bolt (4) and
using new sealing rings - tightening torque 40 Nm
|
| 8. |
Remove MKM-558-10 (5) from brake
fluid reservoir
|
| 9. |
Bleed brake system and check for leaks 
|
| 10. |
Close brake fluid reservoir with closure cap
| • |
Close covering cap for brake fluid reservoir
|
| • |
Place seal on plenum chamber
|
|
|
|
| 11. |
Fit front wheel - tightening torque 110
Nm
|
|
