|
Brake Hose – Rear Axle, Left or Right,
Remove and Install
 Remove
| 1. |
Detach seal from front bulkhead as far as necessary
Note: Remove underbody
air guide plate for "ECO" model version 
| • |
Raise covering flap for brake master cylinder
|
|
| 2. |
Detach closure cap (1) from brake fluid reservoir
| • |
Unclip ABS wiring harness (2) from brake hose
|
|
| 3. |
Detach rear brake lines (4) with retaining plate (3) from rear
axle brake hose.
|
| 4. |
Detach centre brake line (6) with retaining plate (5) from rear
axle brake hose
| • |
Remove brake hose from bracket on vehicle underbody and bracket
on rear axle
|
|
|
|
Install
| 5. |
Insert rear axle brake hose into bracket on vehicle
underbody.
Note: Pay attention to
guide tab on rear axle brake hose and on vehicle underbody
bracket.
|
| 6. |
Connect centre brake line (1) rear axle brake hose using
retaining plate (2) - tightening torque 16
Nm
|
| 7. |
Insert rear axle brake hose into bracket on rear axle
Note: Pay attention to
guide tab on rear axle brake hose and on rear axle bracket.
|
| 8. |
Connect rear brake line (3) to rear axle brake hose using
retaining plate (4) - tightening torque 16
Nm
|
| 9. |
Clip ABS wiring harness (5) to rear axle brake hose
Note: Install underbody
air guide plate for "ECO" model version
|
| 10. |
Remove MKM-558-10 from brake fluid
reservoir
|
|
|
| 11. |
Bleed brake system and check for leaks
|
| 12. |
Install closure cap (1) on brake fluid reservoir
|
| 13. |
Close covering flap (3) for brake master cylinder
| • |
Place seal (2) on plenum chamber
|
|
|
|
|
