|
Brake Line – Rear Left or Right, Remove and
Install (Vehicles with Disc Brakes)
 Remove
| 1. |
Detach seal for plenum chamber as far as necessary.
| • |
Raise covering flap for brake master cylinder
|
|
| 2. |
Detach closure cap (1) from brake fluid reservoir
|
| 3. |
Detach rear wheel
| • |
Mark position in relation to centre of wheel
|
|
| 4. |
Unclip ABS wiring harness from brake line and brake hose
(arrows)
|
| 5. |
Detach rear brake line (3) from rear brake hose
Note: Retaining plate
(2) remains on brake line.
|
| 6. |
Detach rear brake line (5) from brake hose on rear axle and
remove
Note: Retaining plate
(4) remains on brake line.
|
|
|
Install
| 7. |
Lay rear brake line
| • |
Attach rear axle brake hose (1) and rear brake hose (3) with
retaining plates (2) and (4)
| – |
Tightening torque 16 Nm
|
|
|
| 8. |
Clip ABS wiring harness to rear brake line and brake hose
(arrows)
|
| 9. |
Attach rear wheel
| • |
Tightening torque 110 Nm
|
|
| 10. |
Remove MKM-558-10 (5) from brake
fluid reservoir
|
| 11. |
Bleed brake system and check for leaks 
| • |
Attach closure cap to brake fluid reservoir
|
|
| 12. |
Close covering flap for brake master cylinder
| • |
Place seal on plenum chamber
|
|
|
|
|
