J 317700 Oil Dipstick Guide Tube, Replace (Y 17
DT, with AC, LHD)
1. Open bonnet
Caution!
On vehicles from model year 04 with ESP - the steering angle
sensor loses its basic adjustment each time the battery is
disconnected. It must be recalibrated.
2. Disconnect battery
3. Remove air cleaner housing (1)
- Remove wiring harness plug for hot film mass air flow meter
(3)
- Release in direction of arrow
- Remove air intake hose (4)
- Remove bolt (2)
|
|
4. Remove charge air hose
- From turbocharger, centre charge air pipe
5. Raise vehicle
6. Detach ribbed V-belt cover
- Remove 3 bolts (1)
- Remove clip (arrow).
|
|
7. Detach ribbed V-belt
- Tension ribbed V-belt tensioner in direction of arrow
- With KM-913-A
- Note! Mark running direction
|
|
8. Remove oil dipstick guide tube
- From upper part of oil pan
- Remove 2 lower bolts (arrows)
9. Lower vehicle
10. Remove compressor
- Disconnect wiring harness plug
- Remove 3 bolts
- Note! Note dissimilar bolt lengths
- Hang compressor aside
11. Remove oil dipstick guide tube
- Place collecting basin underneath.
- Remove upper bolt (1)
|
|
12. Turn in oil dipstick guide tube
- Replace seal ring
- Screw in upper bolt
13. Install compressor
- Tighten bolts (22 Nm / 16.2 lbf. ft)
- Connect wiring harness plug.
14. Raise vehicle
15. Fasten oil dipstick guide tube
- Tighten lower bolts (9.8 Nm / 7.2 lbf. ft.)
16. Install ribbed V-belt
- Note! Observe running direction and installation position
- Release ribbed V-belt tensioner
17. Attach ribbed V-belt cover
- Tighten bolts
- Install clip
18. Lower vehicle
19. Fasten oil dipstick guide tube
- Tighten upper bolt (9.8 Nm / 7.2 lbf. ft.)
20. Attach charge air hose
- To turbocharger, centre charge air pipe
21. Install air cleaner housing
- Bolt in bolt
- Install air intake hose.
- Fasten clamp (3.5 Nm / 2.6 lbf. ft.)
- Connect wiring harness plug to hot film mass air flow
meter
22. Check and correct engine oil
level
- Observe specified engine oil quantity
23. Connect battery
24. Calibrate steering angle sensor
Note: Rotate the
steering wheel one time from its right-hand to its left-hand
stop.
25. Program volatile memories
26. Close bonnet
|