Remove and install cylinder head cover (Z 12 XE, Z
12 XEP, Z 14 XEP, with air conditioning, LHD)
Remove
2. |
Unclip wiring trough
• |
Lay wiring trough aside.
|
|
3. |
Unclip throttle body preheater hose
|
4. |
Remove ignition module
• |
Remove ignition module cover
|
• |
Disconnect wiring harness connector.
|
• |
Extract using KM-6009 (1)
Note: Do not tilt
|
|
5. |
Remove cylinder head cover
• |
Detach 2 engine vent hoses
|
|
|
|
Install
6. |
Clean sealing surfaces
|
7. |
Attach cylinder head cover (1)
• |
Renew gasket (2) and seal rings
|
• |
Apply sealant (dimension I = 2 mm)
Note: Complete assembly
operations within 10 minutes
|
|
8. |
Attach 2 engine vent hoses
|
|
|
9. |
Install ignition module
• |
Connect wiring harness plug
|
• |
Attach ignition module cover
|
|
10. |
Clip in throttle body preheater hose
|
11. |
Clip-in wiring trough
|
|