Replace ribbed V-belt (Z 12 XE, Z 12 XEP, Z 14
XEP, with air conditioning, LHD)
Note: KM-6394 must be used as of model year 04 instead of
KM-6169-1 .
Remove
2. |
Disconnect battery
Note: On vehicles as of
model year 04 with ESP - the steering angle sensor loses its basic
adjustment each time the battery is disconnected. It must be
recalibrated.
|
3. |
Remove air cleaner housing (1)
• |
Disconnect 2 wiring harness plugs
– |
Hot film mass air flow sensor (3), tank vent valve (2)
|
|
• |
Remove suction pipe (4)
– |
Detach engine vent hose (5)
|
|
• |
For Z 12 XEP, Z 14 XEP: detach air intake hose
|
|
|
|
4. |
Loosen right front wheel.
|
6. |
Remove right front wheel
|
8. |
Remove ribbed V-belt cover
|
|
|
9. |
Attach KM-6169-2 to transmission
|
|
|
10. |
Attach KM-6169 (1)
• |
Attach KM-6169 to left of front axle
body (arrows, illus. I)
– |
Guide pin must be seated in bore in front axle body
|
|
• |
Attach both right holders on the front axle body (arrows,
Illus. II).
– |
Guide pin must be seated in bore in front axle body (arrow,
Fig. III)
|
|
|
|
|
|
11. |
Install support
• |
An KM-6169
– |
Adjust bracket (2) for support
|
|
|
12. |
Adjust supports
• |
Transmission side
– |
Turn spindles until mounts (3) are positioned at guide journals
free of play
|
|
• |
Engine timing side
– |
Insert journal of the support in the bore of the cylinder block
without play (arrow)
|
|
|
|
13. |
Loosen right engine bracket
|
|
|
15. |
Remove right engine bracket
• |
Loosen engine damping block
|
• |
Unscrew 2x bolt (arrows)
|
|
|
|
16. |
Remove ribbed V-belt
Note: Mark running
direction and note installation position
• |
Tension ribbed V-belt tensioner in direction of arrow with
KM-6131 (2)
|
• |
Release ribbed V-belt tensioner
|
|
|
|
Install
17. |
Install ribbed V-belt
Note: Observe running
direction and installation position
• |
Tension ribbed V-belt tensioner with KM-6131
|
• |
Release ribbed V-belt tensioner
|
|
18. |
Install right engine bracket
• |
Tighten upper bolts 60 Nm
|
• |
Fasten engine damping block
|
|
20. |
Fasten right engine bracket
• |
Tighten lower bolt 60 Nm
|
|
24. |
Install ribbed V-belt cover
|
26. |
Attach front right wheel
|
28. |
Fasten right front wheel.
|
29. |
Install air cleaner housing
• |
For Z 12 XEP, Z 14 XEP: attach air intake hose
|
• |
Attach engine vent hose
|
• |
Clip in tank vent valve
|
• |
Connect 2 wiring harness plugs
|
|
31. |
Program volatile memory
|
|