|
J980400 Oxygen Sensor, Mixture Regulation –
Heated, Replace (Z 14 XE, Z 16 YNG with AC, RHD)
|
1. Open bonnet
2. Remove engine cover.
- Unscrew oil filler pipe cap
- Remove 2 bolts
- Screw on oil filler pipe cap
3. Remove heated oxygen sensor, mixture regulation
- Disconnect wiring harness plug (1)
- Carefully screw out KM-6179 (2)
4. Install oxygen sensor, mixture regulation, heated
- Note: Apply special grease to the thread
- Tighten using KM-6179 (30 Nm / 22 lbf. ft.)
- Connect wiring harness plug.
5. Install engine cover.
- Unscrew oil filler pipe cap
- Tighten bolts (8 Nm / 6 lbf. ft.)
- Screw on oil filler pipe cap
6. Close bonnet
|
|
|
