Control unit - replace electronic gear
shifting
Note: When replacing
the control unit, before removal, perform "Reset" with TECH 2.
Remove
2. |
Release wiring harness plugs (1) and (3) and disconnect
|
3. |
Press lug (2) outwards and remove transmission control unit
towards the front.
Note: Different
calibrated transmission control units are used, depending on the
engine and transmission version. When replacing the transmission
control unit, the appropriate transmission control unit must be
used. The latter can be obtained from the "Aftersales"
division.
|
|
|
Install
4. |
Clip transmission control unit into bracket
|
5. |
Attach and lock 2 wiring harness plugs
|
7. |
Program volatile memories
Note: When replacing
the control unit, after installation, "program" with TECH 2.
|
|