|
Remove and install bearing in transmission housing
(F17)
Note: Transmission
remains installed.
 Remove
|
| 1. |
Remove shift mechanism cover (1) 
|
| 2. |
Remove reversing lamp switch (2)
|
| 3. |
Remove end shield cover (3)
|
| 4. |
Remove end shield (4) from transmission
|
|
|
| 6. |
Pull needle bearing (3) for bearing of drive shaft out of
transmission with KM-556-A (1) and MKM-599 (2)
|
| 7. |
Pull roller bearing (4) for bearing of main shaft out of
transmission with KM-556-A (6) and KM-556-2 (5)
|
|
Install
|
Important: Do not drive in roller
bearing flush, otherwise the bearing will be damaged.
|
| 8. |
Drive in new roller bearing (3) for main shaft bearing into
transmission as far as it will go using KM-454-3 (5) in combination with KM-454-4 (4)
|
| 9. |
Drive in new needle bearing (2) for bearing main shaft flush
using KM-454-2 (6) in combination with
KM-454-4 (1)
Note: Needle bearing
side with writing points to transmission.
|
|
|
| 11. |
Install end shield (1) in transmission
|
| 12. |
Install end shield cover (2)
|
| 13. |
Install reversing lamp switch (4) with new seal ring
|
| 14. |
Install gearshift cover (3)
|
| 15. |
Check transmission fluid level
|
|
|
