Replace bearing in transmission housing (F13/F13
MTA)
Note: Transmission
remains installed.
Remove
|
1. |
Remove gearshift cover (1)
|
2. |
Remove reversing lamp switch (2)
|
3. |
Remove end shield cover (3)
|
4. |
Remove end shield (4) from transmission
|
|
|
6. |
Pull needle bearing (3) for bearing of drive shaft out of
transmission with KM-556-A (1) and MKM-599 (2)
|
7. |
Pull roller bearing (4) for bearing of main shaft out of
transmission with KM-556-A (6) and KM-556-2 (5)
|
|
Install
|
Important: Do not drive in roller
bearing flush, otherwise the bearing will be damaged.
|
8. |
Install new roller bearing (3) for bearing of main shaft in
transmission with KM-454-3 (5) in
combination with KM-454-4 (4)
• |
Drive in roller bearing as far as it will go
|
|
9. |
Install new needle bearing (2) for bearing of drive shaft with
KM-454-2 (6) in combination with KM-454-4 (1)
Note: Needle bearing
side with writing points to transmission.
• |
Drive in needle bearing flush
|
|
|
|
11. |
Install end shield (1) in transmission
|
12. |
Install end shield cover (2)
|
13. |
Install reversing lamp switch (4) with new seal ring
|
14. |
Install gearshift cover (3)
|
15. |
Check transmission fluid level
|
|
|