Special tools
Meriva
KM-6002-100
Adapter for KM-6002
To remove/install and align the rear axle with the underside of
the vehicle, with KM-6002, KM-904 and hydraulic jack. KM-6002-100
replaces existing tool part of KM-6002.
Meriva (also for Combo-C, Astra-G and Zafira)
|
|
MKM-883-7
Adapter set for MKM-883-1
To hold the engine
|
|
Astra-CNG
KM-6346
Installer/remover
To remove/install the CNG tank modules for maintenance, repair
and replacement, in conjunction with KM-904 and hydraulic lift
Astra-CNG (Caravan only)
|
|
Omega-B
KM-6393
Remover
To press out bearings from inner bevel pinion (without collar),
in conjunction with KM-6118-1 of tool KM-6118.
Omega-B rear differential
|
|
CVT transmission
Special tools KM-6334, KM-6341, KM-6388, KM-J-43068, KM-J-43069
and KM-J-44969 will be available from September 2003.
KM-6334
Seal plug
To seal the oil cooling pipe connections on the pipe and
transmission side
VT20-E (CVT transmission)
|
|
KM-6341
Transmission holder
To support the transmission when removing and installing it
from/on the engine and when working on the transmission, in
conjunction with KM-113-2
VT20-E (CVT transmission)
|
|
KM-6388
Holder
For securing the torque converter to prevent it from falling
out
First use: VT20-E (CVT transmission)
Additional applications: AF23 and AF33, AF13 and AF17, AF20 and
AF22, 5L40E (Omega) and AR25 and AR35
|
|
KM-J-43068
Installer
To install radial shaft seal in transmission housing (axle
shafts)
VT20E (CVT transmission)
|
|
KM-J-43069
Installer
To install the seal ring on the torque converter
VT20E (CVT transmission)
|
|
KM-J-44969
Installer
To install the sealing ring on the selector lever position
switch
VT20E (CVT transmission)
|
|
Special tool EN-46784 listed in the following will
be supplied on a standing order basis from approx. September
2003.
EN-46784
Installer and remover
For holding the fuel filter housing outside the vehicle when
opening and closing (with a torque of 30 Nm) the screw seal
cap.
Z 13 DT diesel engine
First use: Corsa-C, Agila
|
|
|