| 1. |
Remove attaching parts |
| 2. |
Remove insulating mats in interior if applicable
using hot air gun and putty knife. |
| 3. |
Using centre punch or driver (1) through weld-in
nut (2), mark inside panel (arrow) from below |
| 4. |
Drill punch point visible in interior using drill (
32 - 35 mm ) |
| 5. |
Remove damaged weld-in nut |
| 6. |
Insert new weld-in nut |
| 7. |
Place component (7) to be fastened |
| 8. |
Install screw, counterhold weld-in nut (4) with
suitable tool (3) |
| 9. |
Tighten screw (5) with suitable tool (6) and
required torque while counterholding the nut |
| 10. |
Coat hole edges with paint |
| 11. |
Apply cavity sealant |
| 12. |
Seal hole with gas- and water-tight cover plug
(24441493/51 78 203) |
| 13. |
Fit attaching parts |
