Engine control unit, remove and install (with
start/stop system)
Note: When replacing
the control unit, perform "Reset" using TECH 2 before removing the
control unit.
2. |
Disconnect battery
• |
Detach negative clamp from earth terminal
|
|
3. |
Detach bulkhead closing part
|
4. |
Unlock and disconnect 2 engine control unit wiring harness
plugs (1)
|
|
|
5. |
Remove engine control unit (3)
• |
Unclip front wiring harness (2)
|
• |
Detach engine control unit bracket from engine control unit
|
|
|
|
6. |
Install engine control unit
• |
Attach engine control unit bracket to engine control unit
|
• |
Unclip front wiring harness
|
|
7. |
Connect and lock 2 engine control unit wiring harness plugs
|
8. |
Install bulkhead closing part
|
9. |
Connect battery
• |
Attach earth clamp to earth terminal
|
|
10. |
Program volatile memories
Note: When replacing
the control unit, perform "Program" using TECH 2 after installing
the control unit
|
|