Vauxhall Workshop Service and Repair Manuals

· This value is an internal value of the control unit.

In order to carry out the full-load enrichment, the control unit needs the following data:

1. Throttle valve position

2. Vehicle speed signal.

If one of these signals is not faultless, the control unit cannot carry out the acceleration enrichment correctly.

The full-load enrichment is switched off at engine speeds greater than 4800 rpm. The TECH 1 then displays INACTIVE With a full-load acceleration and an engine speed under 4000 rpm, the TECH 1 displays ACTIVE For further information see also test step 07.

Trouble-shooting:                                 Nominal Value:                       Cause of Fault:

(If nominal value is not attained)

· In case of fault:                                                                                                                   · Carry out test steps 04 and 05.