· The control unit has determined a voltage level
at output
Ter. D 10 to ignition module (EST lead) during
starting which does not correspond to the nominal value (6 consecutive 0 V to
12 V transitions were not registered)
· (Short circuit to ground)
If
trouble code 64 was recognized, the EST lead (D 10) is switched off.
Note:
A
fault in the control unit programming means that the TECH 1 display changes
between "TC PRESENT" and "TC NOT PRESENT" as soon as a
fault is recognized.
If
trouble code 64 was recognized, the system telltale is switched on.
If
trouble code 64 was recognized, the system telltale remains switched on until
the ignition is switched off.
|