|
No.
|
TECH 1 Display
|
Conditions for
Checking
|
Nominal Value
|
Trouble Codes
|
Terminal
|
|
|
26
|
I.MIRROR V.
MOTOR
|
Ignition ON
None of the three personal keys pressed
|
INACTIVE
|
19
|
13,
24
26-pin
plug
|
|
|
|
|
Tilt inside mirror fully forwards
Press one personal key and hold down while mirror moves to
the stored position
|
UP
|
|
|
|
|
|
|
Tilt inside mirror fully backwards
Press one personal key and hold down while mirror moves to
the stored position
|
DOWN
|
|
|
|
|
Notes on Trouble-shooting:
|
Nominal Value:
|
Cause of fault:
(If nominal value is not
attained)
|
|
· Ignition OFF, remove inside mirror
· Release 12-pin wiring harness
connection for inside mirrors and separate
· Ignition ON
· Carry out F5:ACTUATOR TEST, test step 6
· During check, measure voltage in 12-pin
wiring harness coupling between Ter. 2 and Ter. 3 using multimeter
|
higher than 10 V
|
· Interruption or short circuit to ground
in body wiring harness between 12-pin wiring harness coupling (inside mirror
connection) and 26-pin wiring harness plug for control unit K103
· Control unit K103 defective
|
|
|
· Ignition OFF
· Using multimeter, measure resistance in
12-pin wiring harness plug for inside mirror between Ter. 2 and
Ter. 3
|
approx. 160 W
|
· Lead interruption or inside mirror
motor M29 defective
|
|
|
· Install inside mirror again
|
|
|
|
|
· Ignition OFF, disconnect battery
negative terminal
· Remove driver's seat
· Release 26-pin wiring harness plug from
control unit and disconnect
· Using multimeter, measure resistance in
26-pin wiring harness plug between Ter. 23 and Ter. 13
|
approx. 160 W
|
· Interruption in body wiring harness
between inside mirror motor M29 and 26-pin wiring harness plug for control
unit K103
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
