|
No.
|
Remedy
|
|
1
|
Fasten driver's seat to vehicle floor with 4 new
bolts.
|
|
2
|
Remove driver's seat and bolt firmly to seat console.
|
|
3
|
Remove panelling from driver's seat. Check seat
adjustment switch and seat panelling for material damage. Replace defective
parts. Fasten switch in such a manner that all switch functions can be
performed without jamming when panelling is installed.
|
|
4
|
Remove driver's seat. Clean lower and upper seat
console rails and regrease. Before installing seat, check that upper and
lower rails can slide smoothly.
|
|
5
|
Remove driver's seat. Check drive mechanism for dirt,
jammed foreign bodies and material faults. Replace defective parts. Check
that motor is firmly seated and check function of transfer pipe. If drive
mechanism is okay, replace motor.
|
|
6
|
Remove driver's seat. Disassemble seat console and
re-assemble as specified in Omega-B Service Instructions, group C. Always
make sure that the upper and lower rails are flush on top of one another.
|
|
7
|
Carry out F7:PROGRAMMING
with TECH 1 according to table 7
|
|
8
|
Remove driver's seat. Check motor, flexible cable,
gears and fastening parts in backrest for firm seating and material faults.
Replace defective parts. Check function of drive mechanism and check for easy
movement. If drive mechanism is okay, replace motor.
|
|
9
|
Remove driver's seat. Check assembly of motor,
flexible cable and gears in backrest, and also assembly of backrest with
panelling and upholstery as described in Service Instructions, group C.
|
|
10
|
Move seat position forwards or backwards with
emergency crank until relevant driver's seat fastening bolts are accessible
and can be loosened.
|
|
11
|
Remove panelling with rocker switches and keys (switch
unit S40) from driver's seat and check for material damage. Replace defective
parts. Check that switch unit S40 is correctly fastened and fasten in such a
manner that all rocker switch and key functions can be performed without
jamming
|
|
12
|
After removing mirror corner panel, bolt outside
mirror firmly to door
|
|
13
|
Fasten mirror motor in mirror casing
|
|
14
|
Replace mirror cover
|
|
15
|
Unclip mirror face. Check brackets for material
damage. If necessary, replace mirror face and clip onto mirror motor
|
|
16
|
Replace mirror cover
|
|
17
|
Remove handle from driver's door. Check mirror
adjustment switch and handle for material damage. Replace defective parts.
Insert mirror adjustment switch in handle recess and press in firmly until
fastening clips engage
|
|
18
|
Replace inside mirror
|
